
Short answer: Automatic mantrap doors in Dubai form a small vestibule with two doors that cannot open at the same time. A controller lets the inner door open only when the outer door is closed and locked, and the other way round. Access control decides who may start the sequence, and a clear fail-safe plan covers power loss and fire alarms.
What a mantrap is
A mantrap, also called an interlocked entry or a security vestibule, is a small space between two doors. A person enters the first door, it closes behind them, and only then can the second door open. This stops tailgating and lets staff or systems check a person before they go further. The doors can be automatic sliding, swing or a mix. Many sites use glass so that people inside can be seen.
How the interlock logic works
Each door has a position sensor that tells a controller whether it is closed. Each door also has a lock or a motor that holds it shut. The controller applies simple rules:
- Door A may open only if door B is closed and locked.
- Door B may open only if door A is closed and locked.
- After a person enters, door A closes and locks before door B is released.
- If a door is held open or fails to close, the controller raises an alarm and keeps the other door shut.
Indicator lights, either red and green or a similar sign, show which door is available. Some sites add a weight check or presence sensor to confirm that only one person is inside the vestibule.
Linking to access control
The mantrap controller does not decide who is allowed in. Access control does that, using a card, a PIN, a fingerprint or a face scan. When the reader says yes, the controller starts the sequence. Often the outer door uses a reader on the outside, and the inner door uses another reader inside. See access control systems, biometric access control and our access control guide. For data sites see automatic doors and access control for data centres.
Fail-safe behaviour
This is the hardest part and the most important. Two questions must be answered in writing before the equipment is ordered.
| Event | Question to settle |
|---|---|
| Power loss | Do the doors fail open for escape, or fail closed for security with a manual release inside? |
| Fire alarm | Do both doors release so that no one is trapped? |
| Controller fault | Is there a manual override, and who holds the key? |
| Emergency button | Where is it, and what does it release? |
Life safety comes first. The building's fire engineer and the site's security lead should agree the behaviour. We follow the manufacturer's instructions and never disable a safety device. Ask the manufacturer's data sheet for the exact fail-safe options of each model.
Where mantrap entries are used
- Server and data rooms.
- Laboratories and clean areas.
- Secure stores, cash rooms and archives.
- Controlled lobbies in sensitive offices.
- Entry points where staff and visitors must be screened separately.
For a mantrap that uses sliding leaves, see automatic sliding glass doors. For layouts that combine a revolving door and a side door, read our revolving door guide. The full service is described under mantrap security doors and installation in Dubai.
Frequently asked questions
Can a mantrap be fitted into an existing lobby?
Often yes, if there is enough depth between the two doors to hold a person comfortably, plus clear floor space for a wheelchair or a trolley when required. We measure the lobby, check the structure, the power supply and the cable routes, and tell you what changes are needed. Sometimes one existing door is reused and only one new door is added.
What stops someone from following a person through?
The interlock does. The inner door will not unlock until the outer door has closed and locked. If a second person tries to step in with the first, the controller can keep the inner door shut and raise an alarm, depending on how it is set up. A presence or weight sensor can add another check. No system is perfect, so it works best together with staff procedures.
Is a mantrap safe in a fire?
It must be designed to be. The controller is linked to the fire alarm so the doors release and people can leave. A manual release inside the vestibule gives a second route. The exact arrangement is agreed with the building's fire engineer and the site's security lead before any equipment is ordered. We do not offer a one-size answer, because it depends on the building.
What happens if one door fails to close?
The controller keeps the other door shut and flags a fault. A door may fail to close because of an object in the path, a damaged seal, a sensor that is dirty or a lock that has stuck. The status lights and a log, if fitted, point the technician to the cause. This is why regular testing of the interlock is part of any service plan.
Does a mantrap need maintenance?
Yes, more than most doors. Sensors, locks, controllers and indicator lights all have to work in step. A service tests the interlock sequence, the fail-safe release, the readers and the manual overrides, and cleans sensors and tracks. Dust is an issue in Dubai, so cleaning matters. We can propose a service routine after we see how the entry is used.
Planning a secure entry?
Send photos or drawings of the lobby through our photo page or request a written quote at the quote form. You can also message us on WhatsApp at 971504948667 or call +971 50 494 8667. The site visit is free.
Want this done properly?
Send a photo of your door or gate and we will tell you what we see.