
Short answer: If you rent, ask your landlord in writing before you order a new door, gate or opener. If the property sits in a master community or a managed building, the community or building management usually needs to approve as well. One letter with the exact change, a photo, the product datasheet, who will do the work and how the opening will be restored gives the approver everything they need to say yes.
In short
- Ask first, in writing, and keep the reply. A verbal yes does not help at the end of the tenancy.
- In a villa community or tower, the landlord is rarely the only approver.
- Attach a photo, a datasheet and installer details. Vague requests get slow answers.
- Offer to restore the original at the end of the tenancy.
- If the answer is no, ask which conditions would turn it into a yes.

Do I need my landlord's permission to change a door or gate in Dubai?
Almost always, yes, if the change is fixed to the building. A garage door, a gate motor or a new entrance door is a fixture. It changes walls, tracks, power cables and the look of the frontage, so it sits under the alterations clause of most tenancy contracts. Read that clause first. Some contracts forbid all alterations, some allow them with written consent, and some allow reversible work only.
Then check who else decides. Villas in a master community such as Arabian Ranches or Dubai Hills Estate normally follow community design rules for colour, panel style and visible hardware. Apartments and shops in a managed building follow the building management's rules for facades, lobbies and fire exits. Our short answers on landlord or community approval for a villa garage door and permission for a sliding gate on a Dubai villa cover the two common cases. Rules differ by community and change over time, so confirm with the landlord and the management office rather than relying on any general guide, including this one.

What should the request letter contain?
A good request is short and specific. The approver should be able to read it in two minutes and answer yes, no or "change this". Include the items in the table below.
What each part of the letter does
| Part of the letter | What to write | Why the approver cares |
|---|---|---|
| Your details | Name, unit or villa number, tenancy contact number | Confirms who is asking and for which property |
| The change | Door, gate or opener, size of the opening, colour, panel style | Lets them judge the look from the street |
| Fixing method | Where it is fixed: floor, wall, ceiling, post. Any drilling or cutting | Shows whether the structure is touched |
| Power and cables | Where power comes from and where cables run | Avoids surprise trenching or visible conduit |
| Who does the work | Installer name, contact, planned dates and working hours | Management needs this for access passes |
| Restoration | A promise to restore the original opening at the end of the tenancy if asked | Removes the landlord's main worry |
| Attachments | Photo of the opening, datasheet, drawing or sketch | Turns a vague idea into something they can approve |
Is there a letter template I can copy?
Yes. Copy the text below, replace the square brackets, and send it by email or the channel your landlord uses so you hold a written trail. This is a plain request, not legal advice. If your contract is unusual, ask the landlord or a legal adviser how to word it.
Request template
To: [Landlord name] / [Community or building management office]
Subject: Request to replace the [garage door / entrance door / gate] at [villa or unit number, community or building]
Dear [name],
I am the tenant of [villa or unit number]. I would like your written permission to replace the [garage door / entrance door / gate] at the property. The opening is about [width] by [height] and the new [door / gate] will be [colour and style]. It will be fixed to [floor, wall or ceiling, and any drilling]. Power will come from [existing socket or point] and cables will run [route].
The work will be done by [installer name and contact] on [planned dates] during [working hours]. I attach a photo of the current opening, the product datasheet and a sketch of the new layout. At the end of the tenancy I will restore the original opening if you ask.
Please reply in writing with your approval or any conditions. If the management office needs a separate form or contractor details, please send them to me.
Regards, [your name, phone, email]
Which attachments speed up approval?
Three attachments do most of the work. A clear photo of the existing opening from the street shows what is there today. The manufacturer's datasheet shows what will be fitted: type, finish, motor and safety devices. A sketch with the opening size and the fixing points shows how it goes in. If you use us, we can supply a datasheet and a marked-up photo after a visit.

Matching the new door to the old one helps in a community. A cream sectional door replaced by another cream sectional door in the same panel style rarely worries a design reviewer. A new colour, glass panels or a change from a swing to a sliding gate draws more questions, so describe it carefully and attach a picture. For the products themselves, see our residential garage doors, garage door openers and automatic sliding gates.
What do landlords and management actually worry about?
They worry about damage, appearance, safety and what is left behind. If your letter answers these four, most requests move quickly.
- Damage. Drilling into a slab, cutting a wall, or chasing cables into plaster. Say what is touched and how it will be made good.
- Appearance. Colour, panel style and visible motors on a street frontage. Attach the picture.
- Safety. A gate or door that moves must stop and reverse on an obstacle, and it must not block an exit route. Ask the installer to state which safety devices are fitted. Fire exit rules belong to the building and the authority, so confirm them with the management.
- What is left behind. A motor, track or remote system that the next tenant cannot use. Offer to restore, or agree that it stays.
Heat and dust matter too, and a landlord who has seen a failed cheap motor will ask about them. In a place like JBR or near the Marina, salt air shortens the life of exposed steel parts, and a surface that looks fine at handover can show rust within a season. Say which finish and fixings you plan to use. See our note on lobby doors and car park gates in sea air for what holds up.

Who answers, and in what order?
Ask the landlord first, because the landlord is your contract party. Ask the community or building management at the same time if you can, because their review often takes longer. The table shows the usual chain for four property types. Confirm the details with your own landlord and office.
Who to ask by property type
| Property | Usual first approver | Also check with |
|---|---|---|
| Villa in a master community | Landlord | Community design or owners office |
| Apartment with its own garage or parking door | Landlord | Building management |
| Shop or unit in a mall or managed block | Landlord | Mall or building management, fit-out rules |
| Warehouse or industrial unit | Landlord | Zone or park management, fire safety rules |
What if the landlord says no or does not reply?
Ask a second question: what would make it a yes? A refusal often comes from one worry, such as appearance or drilling into the slab. Offer a reversible solution. A new opener on the existing door, a motor that bolts to the existing post, or a remote added to a motor that is already there can all be done with little change to the structure. Our note on replacing just the opener and keeping the door explains that route. For gates, gate motors that bolt onto an existing gate are often easier to approve than a new gate.

If there is no reply after a polite follow up, do not go ahead on silence. Send a short reminder, copy the management office, and keep the thread. Work done without consent can leave you paying to take it out.
What to send us
- A photo of the opening from the street, and one from inside.
- The width and height of the opening if you have them, or a phone photo with a tape measure in view.
- The brand on the existing motor or gate, if there is one (for example BFT, CAME or FAAC).
- Your community or building name and whether you rent.
- A copy of the community or management guideline, if you have it.
How does Mount Everest help with the paperwork?
Mount Everest Automatic Doors is an installer and service company. We do not manufacture the doors, gates or motors we fit. Our base is in Al Quoz, Dubai. After a visit we can give you a datasheet for the product, a sketch of how it fits and the installer details the approver will ask for, and we adapt to the management's own form if they have one. We do not apply to the community for you, and we cannot promise an answer, but a complete pack saves a round of questions.
See a recent job: the garage door installation in The Meadows. The record shows a white raised-panel sectional garage door during installation. If your existing gate already has a CAME motor, our CAME brand page lists what we service. Browse the sectional doors and gates pages for the range, and read what to ask building management before changing a door or gate for the questions to put to the office. If the work is for a rented shop or a block you manage, a maintenance contract keeps the new equipment in order after the change.
Frequently asked questions
Is a verbal yes from the landlord enough?
It is risky. A verbal yes cannot be shown to a new landlord, to the management office or at the end of the tenancy when someone asks who approved the work. A one line email reply that says "approved as described" costs the landlord nothing and protects you. Ask for that reply and keep it with your tenancy papers.
Can I change only the remote or the motor without asking?
Usually less permission is needed, because nothing structural changes. Replacing a remote or a board on a motor that is already fitted is routine maintenance. Replacing the motor with a different type, adding drilling or changing the appearance is an alteration. When in doubt, send the landlord a two line message and a photo.
Does the community have to approve a garage door colour?
In many master communities, yes. Colour, panel style and glazing are often part of the design rules, and a change can be refused or have to be reversed. Check the community's guidelines or office before you order. Matching the existing colour and panel style is the easiest request to get approved.
Who pays for the new door or gate?
That depends on your contract and what you agree. In general, a tenant who asks for an upgrade pays for it, and a landlord who replaces a worn item pays. Our guide to maintenance contracts shows what a service agreement usually covers. Agree the answer in the same email as the approval.
What if I move out soon after?
Ask whether the landlord wants the new equipment to stay or the original restored. Many landlords are glad to keep a working motor and remote. Put the answer in writing, together with the remotes and codes you will hand over, so the move out inspection has no surprises.
Can the installer send the request for me?
An installer can give you a datasheet, a sketch and contractor details, but the request itself comes from the tenant, because the contract is yours. Some management offices also want the installer's trade licence and insurance papers. Ask the office what it wants and we will supply what we can.
Ready to prepare your request?
Call +971 50 494 8667 or use the quote form. Send photos of the opening through send a photo, or book a site visit so we can measure and prepare the datasheet and sketch. We work in Dubai first and book jobs in other emirates by appointment. We give a written quote after seeing the job, and we do not guess prices.
Want this done properly?
Send a photo of your door or gate and we will tell you what we see.